-
Whitewall
width: 2 1/2"
-
Recommended Rim
Widths: 5.5 - 7.5"
-
Construction:
Poly/Steel
-
Load/Speed
Index: 100P
-
Maximum Load
Capacity: 1742 pounds at 35 Pounds Per Square Inch Air
Pressure
-
Tread Width:
6.04 inches
-
Section Width:
8.63 inches
-
Overall
Diameter: 27.62"
-
-
Coker Steel Belted
Radial Details
-
Construction: Polyester cord with steel
belts
-
All 14 and
15 inch Coker Classic Nostalgia radial tires are tubeless.
16 inch tires require tubes.
-
All sizes
are both DOT and ECE marked. ECE is the
certification for the European market.
-
UTQG:
15" Tread wear: 400. 16" tires: 350. Traction B, represents the
tire's ability to stop on wet pavement.
Temperature: B, represents the tire's
resistance to the generation of heat and its
ability to dissipate heat.
-
Approximate
mileage: 35,000 - 40,000. Note: this is an estimate,
not a warranty.
-
Recommended
PSI for 14 and 15" tires: 35 PSI. 16"
tires: 40 PSI. Low air pressure can cause the
sidewall to crack or lead to tire failure.
-
Mounting/Balancing Recommendations: Static
balance with the weights on the inside of
the tire only in order to protect the soft
whitewall. This also gives a more pleasing
appearance.
-
Recommend the use of lug centric
balancing over hub centric. Due to the
cosmetic whitewall insert these tires may
take 3 to 5 ounces to balance, this is
normal.
-
75 series
feature an all season tread design.
-
The whitewalls, redlines and redlines
are molded into the tire, not added on after
the tires are made.
-
Caution:
When converting a bias to a radial, the 75
series will be closer to the 78 or 80 series bias
size. Going larger may result in fitment
issues on some applications, especially when
using fender skirts.
-
All listed
measurements are non-scientific and may
change with different rim widths.
-
Never mix
bias and radials on the same vehicle because
the vehicle may steer uncontrollably.
-
Old rims can
often be out-of-round and should be
carefully checked before mounting.
-
Older rims
designed for bias-ply tires may crack if
used with modern radials, as the radial
places more stress on the wheel.
- *Please order your tires
carefully. Let us help you. If you need to return tires and it
is not our fault, there is a 20% re-stocking fee.
- Tires must be
returned in the same condition as shipped and not mounted. We
cannot accept tires that have been mounted. Shipping costs are
the responsibility of the customer.
- IMPORTANT
INFORMATION!
-
If you run
inner-tubes with your tires, it is imperative
that you carefully inspect and remove all
stickers on the inside of the tires. We have
found as many as six inspection stickers. They
are not always easy to remove. We have used a
hair dryer to loosen them up. If you do not
remove these stickers, they can puncture your
inner-tubes and cause a flat tire which could be
a safety-hazard. Please call us if you have any
questions on this important issue.
-
Coker Classic Nostalgia radial tires are designed
for pre-1976 vehicles and have modern aspect
ratios, so interchangeability is not implied nor
always possible because of rim widths, wheel
well clearance and speed and load ratings
required.
-
It is very important to maintain proper
inflation pressure (35 psi MINIMUM) on Coker
Classic Nostalgia radial tires. 16" tires
require 41 psi.
-
Vehicles designed for bias ply tires may drive
considerably different with radial ply tires.
Please use extreme caution.
-
Older rims that were originally designed for
bias-ply tires may crack if used with modern
radial tires. Please use caution by inspecting
your rims on a regular basis.
-
Thank you.
-
