- Redline Width: 3/8"
- Recommended Rim Widths: 5.5 - 7.5"
- Construction: Poly/Steel
- Load/Speed Index: 95S
- Maximum Load Capacity: 1565 pounds at
35 Pounds Per Square Inch Air Pressure
- Tread Width: 6.40 inches
- Section Width: 8.70 inches
- Overall Diameter: 27.01"
- Asymmetrical tread design provides optimum traction and handling performance.
All season tread design.
Outstanding ride and long tread-life.
Polyester cord with steel belts
DOT and ECE certified
UTQG: Treadwear 540, Traction: B, Temperature: B
Approximate estimated mileage: 45,000
Recommended air pressure: 35 PSI
Whitewalls are molded into the tire during construction, not added on later.
- Handcrafted in the USA.
BFGoodrich Silvertown radial tires are designed
for pre-1976 vehicles and have modern aspect
ratios, so interchangeability is not implied nor
always possible because of rim widths, wheel
well clearance and speed and load ratings
It is very important to maintain proper
inflation pressure (35 psi MINIMUM) on BFG
Silvertown radial tires.
Vehicles designed for bias ply tires may drive
considerably different with radial ply tires.
Please use extreme caution.
Older rims that were originally designed for
bias-ply tires may crack if used with modern
radial tires. Please use caution by inspecting
your rims on a regular basis.
Never mix bias and radial
tires on the same vehicle. Your vehicle may over or under-steer, causing you
to lose control of your vehicle.
If you run inner-tubes
with your tires, it is imperative that you carefully inspect and
remove all stickers on the inside of the tires. We have found as
many as six inspection stickers. They are not always easy to
remove. We have used a hair dryer to loosen them up. If you do
not remove these stickers, they can puncture your inner-tubes
and cause a flat tire which could be a safety-hazard. Please
call us if you have any questions on this important issue.
Please order your tires
carefully. Let us help you. If you need to return tires and it
is not our fault, there is a 20% re-stocking fee.
Tires must be
returned in the same condition as shipped and not mounted. We
cannot accept tires that have been mounted. Shipping costs are
the responsibility of the customer.