Please order your tires
carefully. Let us help you. If you need to return tires and it
is not our fault, there is a 20% re-stocking fee.
Tires must be
returned in the same condition as shipped and not mounted. We
cannot accept tires that have been mounted.
Shipping costs are
the responsibility of the customer.
If you run inner-tubes
with your tires, it is imperative that you carefully inspect and
remove all stickers on the inside of the tires.
We have found as
many as six inspection stickers in one tire. They are not always easy to
remove. We have used a hair dryer to loosen them up.
If you do
not remove these stickers, they can puncture your inner-tubes
and cause a flat tire which could be a safety-hazard.
call us if you have any questions on this important issue.
BFGoodrich radial tires are designed
for pre-1976 vehicles and have modern aspect
ratios, so interchangeability is not implied nor
always possible because of rim widths, wheel
well clearance and speed and load ratings
It is very important to maintain proper
inflation pressure (35 psi MINIMUM) on BFG radial tires.
Vehicles designed for bias ply tires may drive
considerably different with radial ply tires.
Please use extreme caution.
Older rims that were originally designed for
bias-ply tires may crack if used with modern
radial tires. Please use caution by inspecting
your rims on a regular basis.
Never mix bias and radial tires on the same
vehicle. Your vehicle may over or under-steer,
causing you to lose control of your vehicle.
Construction: Polyester cord with steel
All BFG radials are tubeless
are both DOT and ECE marked. ECE is the
certification for the European market.
Treadwear: 400. Traction A, represents the
tire's ability to stop on wet pavement.
Temperature: B, represents the tire's
resistance to the generation of heat and its
ability to dissipate heat.
PSI: 35 PSI. Low air pressure can cause the
sidewall to crack or lead to tire failure.
Mounting/Balancing Recommendations: Static
balance with the weights on the inside of
the tire only in order to protect the soft
whitewall. This also gives a more pleasing
appearance. Recommend the use of lug centric
balancing over hub centric. Due to the
cosmetic whitewall insert these tires may
take 3 to 5 ounces to balance, this is
rated. (112 miles per hour - sustained
When converting a bias to a radial, the 75
series will be closer to the 78 or 83 series bias
size. The 70 series may rub in in some
applications, especially with fender skirts.
measurements are non-scientific and may
change with different rim widths.
bias and radials on the same vehicle because
the vehicle may steer uncontrollably.
Old rims can
often be out-of-round and should be
carefully checked before mounting.
designed for bias-ply tires may crack if
used with modern radials, as the radial
places more stress on the wheel.